Boundary layer wind funeral laboratory

Maximum wind speed 25m/s, measurement section 2.5×2.0×21m3
This wind tunnel is equipped with a long measurement barrel measuring 21m. It can create a variety of airflow properties, from uniform airflow with a maximum wind speed of 25m/s to turbulent airflow similar to natural wind. The cross-section of the measuring section is 2.5 m wide and 2 m high, and the model can be rotated 360° using a 2 m diameter turntable. The turntable can be used in two locations: upstream and downstream of the measuring cylinder. The downstream end is open to the outside, and the wind blows out, so experiments on test specimens that do not fit in the measurement section can be performed using the air outlet. Inside the wind tunnel, you can measure wind pressure using a pressure sensor, wind force using a 6-axis balance, and wind speed using a hot-wire anemometer.

Installation Location

82 Boundary layer wind funeral laboratory

Check on the map

Print the map

User Guide

Kyoto University

Device Use

Those who are proficient in the use of machinery are desirable. The unit of use is one day.

Please contact the person in charge of the equipment for details.

Other Research Institutes

Device Use

Those who are proficient in the use of machinery are desirable. The unit of use is one day.

Please contact the person in charge of the equipment for details.

Companies, etc.

Device Use

Those who are proficient in the use of machinery are desirable. The unit of use is one day.

Please contact the person in charge of the equipment for details.

Device Use: A joint research agreement must be signed (Prior consultation is possible before applying for a public offering)

User Guide

Please check the shared use facilities page of the Kyoto University Disaster Prevention Research Institute.

Inquiries

Research Division of Atmospheric and Hydrospheric Disasters. Takashi Maruyama